Login
Lexicon
Transformers Fanfics, Essays, Author Interviews and More...! Established 1996!

Excillion by Firestorm

[ - ]   Printer Table of Contents

- Text Size +
            As I’ve often mentioned, thanks to the local yard sales I’m able to cheaply add more figures to my collection. While most of these are older figures or even bootlegs, on rare occasions I’ll get something fairly recent. Such is the case with Excillion.

            Ultimately, Excillion is a repaint of Cybertron Hot Shot. Anyone looking at his paint scheme will immediately recognize it as an homage to G1 Hot Rod, something that everyone should be familiar with as – not counting Classics – all three portions of the A/E/C trilogy have had Hot Rod or Rodimus Prime homages. While Hasbro is apparently trying to play up the nostalgia factor, IMHO this is a bit much.

            The vehicle mode doesn’t have too terribly many thrills to it; it’s a sports car and nothing more. Plugging in his Cyber Planet Key will activate his power: a pair of energon wings. With Hot Shot, these wings worked; they would give him boosts of speed over short distances. But with Excillion? His profile posits him as a high-speed commando, meaning that the wings would only be marginally useful. He can mount his weapon in this mode, however, and given that it mounts to his roof it could theoretically be used as a turret (something which is in keeping with his profile).

            Transformation to and from robot mode is a little tricky as the windows and cabin sections actually interlock, but it does get easier with time. Once in robot mode, though, the figure still has some issues. For starters, his weapon is so large due to the spring-loaded mechanism that it interferes with the elbow joint on that arm; he literally can’t shoot from the hip. The figure also has a shoulder section that contains two joints: a swinging joint on which the arm hangs, and a rotational joint upon which the shoulder section is mounted. Problem is, due to the placement of the rotational joint and the size of the shoulder section, rotating the arm while the wings are out won’t work right; the shoulders will rub against the wings. Plus, due to his transform he doesn’t have any waist articulation.

            His elbow and hip joints are ball-and-socket joints, meaning that he’s got a fairly good range of motion. He’s also got articulated knees, allowing for some additional play value there. Of note is that the lower section of his knees is actually a separate piece of plastic that is sandwiched between the two sections of his lower leg. Based on a surface examination one would think that the leg may have originally been designed to extend a little more (a similar situation to G1 Hot Rod), but my long-tipped Phillips screwdriver of the appropriate size has gone MIA and so I can’t crack him open to check.

            Special note should be given to the paint job. The sections representing his doors are actually made from the translucent blue plastic used for his windows. As such, the doors have been painted in place. This means that the red on the doors (like on the roof pillars) is a much brighter shade of red than the rest of the toy; even in the limited lighting I’ve got here, I can still tell the difference. The paint also didn’t get applied to the edges of the door section, meaning that the translucent plastic is visible; it makes the small gap between the doors and the rear section look a lot bigger than it really is. On mine, the paint masking on the torso was also off; there are a few splotches of paint on areas that should be bare.

            Overall? He’s a good figure, and a pretty decent attempt at making a new character from an old mold. But the mold’s own problems have been exacerbated by the paint job, both its staleness and the other problems involved. Go ahead and snag him if you don’t have the other Hot Shot mold, but there’s nothing special to him. Rating: 6 / 10.